1 review for GB: Clamp On & Set Screw
You must be logged in to post a review.
GB: Clamp On & Set Screw
GB: Clamp On & Set Screw Gas Blocks
GB: Clamp On & Set Screw
From: $64.95
Built to the tightest tolerances, the VLTOR low profile, clamp on and set screw gas blocks are small enough to fit inside most rail systems. These gas blocks were designed to be used when a rail system/handguard that is mounted over the entire gas system.
Export Control:
Many of VLTOR’s products are export controlled by the International Traffic in Arms Regulations (ITAR). Shipments from VLTOR may contain products controlled by the U.S. DoS or the U.S. DoC. Export of such items may not be done without prior approval from the U.S. Government and VLTOR.
AVAILABLE OPTIONS:
- Made from 17-4 PH Stainless Steel
- Comes in Matte Black Oxide or Matte Gray Silver (both anti-reflection/anti-glare)
- Three bore diameters available: 0.750”, 0.625”, or 0.875″.
Color(s)
Matte Black Oxide or Matte Gray Silver (both anti-reflection/anti-glare)
- Overall Length: 1.00 inch
- Overall Width (0.625” bore): 0.800 inch
- Overall Width (0.750” bore): 0.925 inch
- Overall Width (0.875″ bore): 1.00 inch
- Height from centerline of bore to top of gas block: 0.402″
- Bottom Thickness (measured from centerline of the bore of 0.625 inch gas block):
0.500 inch- Set Screw Gas Block
0.600 inch- Clamp Gas Block
- Bottom Thickness (measured from centerline of the bore of 0.750 inch gas block):
0.560 inch- Set Screw Gas Block
0.600 inch- Clamp Gas Block
- Weight:
1.4 oz- Set Screw Gas Block
1.6 oz- Clamp Gas Block
docgrit –
I installed the GB-2C on my WW SRC under a 10 inch ALG EMR rail (the non M-LOK one). Looks fine to me but I have not fired weapon yet. I do not believe an M-Lok will not work under this gas block using any 10 inch ALG rail. I am thinking about going with the newer ALG type rail that accepts M-LOK but in a 12 inch length. Did i also mention I also installed a VLTOR Mod 4 charging handle too. Excellent also.